remove your unused USB device information form your register.

USB Storage Device Problems? How to Cleanup and Remove old USB Mass Storage Drivers - TechSpot OpenBoards
USB Storage Device Problems? How to Cleanup and Remove old USB Mass Storage Drivers - TechSpot OpenBoards: "- 已使用 Google 工具列寄出"

nice software! it could remove your many many unused USB device information form your register.

GSR600 TPS ( Throttle Position Sensor) adjustment

FI MODE

DEALER MODE (FI MODE code )
BLACK W/ GREEN BAND Wire with a WHITE STRIPE and a
WHITE W/ GREEN BAND Wire with a RED STRIPE
黑底白細條
白底紅細條
短路後 就可以看 FI code了



C11 - Camshaft position sensor (CMPS)
C12 - Crankshaft position sensor (CKPS) Pick-up coil signal, signal generator
C13 - Intake air pressure sensor (IAPS)
C14 - THROTTLE POSITION SENSOR
C15 - ENGINE COOLANT TEMPERATURE SENSOR
C21 - INTAKE AIR TEMPERATURE SENSOR
C22 - ATMOSPHERIC PRESSURE SENSOR
C23 - TIPOVER SENSOR
C24 - IGNITION SIGNAL #1
C25 - IGNITION SIGNAL #2
C26 - IGNITION SIGNAL #3
C27 - IGNITION SIGNAL #4
C28 - SECONDARY THROTTLE VALVE ACTUATOR
C29 - SECONDARY THROTTLE POSITION SENSOR
C30 - SECONDARY THROTTLE CONTROL UNIT
C31 - GEAR POSITION SENSOR
C32 - INJECTOR SIGNAL #1
C33 - INJECTOR SIGNAL #2
C34 - INJECTOR SIGNAL #3
C35 - INJECTOR SIGNAL #4
C41 - FUEL PUMP CONTROL SYSTEM
C42 - IGNITION SWITCH SIGNAL
C44 - HO2 sensor
C49 - PAIR control solenoid valve
C60 - Cooling fan control system ( Cooling fan relay)

TP SENSOR ADJUSTMENT


TPS ADJUSTMENT
1. Adjust the engine rpm to 1 300 r/min. (2-15)
2. Connect the special tool (Mode select switch) to the dealer
mode coupler at the wiring harness.
3. If the throttle position sensor adjustment is necessary, remove
the air cleaner box (5-13) and follow the procedure
below.
4. Loosen the screw and turn the throttle position sensor 1 and
bring the line to the middle.
5. Then, tighten the screw to fix the throttle position sensor.